Rigol DS6000 Series Manuel d'utilisateur télécharger pdf (Page 54)

RIGOL

18 User’s Guide for RP7000 Series Active Probe

① Solder-in differential probe head (RP7-0201).

② 0.2mm Nickel Wire (RP7-0306).

When the points to be tested are widely spaced, the length of the nickel wire

will be increased. At this point, overshoot and ringing will occurs and the

high-frequency response will changes.

4. Solder-in Single-ended Probe Head

The solder-in single-ended probe head provides an effective bandwidth of more

than 1.5GHz and its replaceable nickel wire enhance the usability of the probe

and prolong its service life.

The structure of the solder-in single-ended probe head is as shown in Figure

12.

The pin on the same side with the negative pole mark sleeve (refer to Figure 8)

is negative.

Figure 12 Solder-in Single-ended Probe Head

①

②

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 62 63

Pas de commentaire

Rigol DS6000 Series Manuel d'utilisateur Page 54