Rigol MSO/DS2000A Series Manuel d'utilisateur télécharger pdf (Page 1)

2 Installation Tool

PH2 Phillips Screwdriver (recommended).

3 Installation Space

The following requirements must be fulfilled by the machine cabinet in which the instrument

is mounted.

 The machine cabinet must be a standard 19-inch one.

 At least 5U (222.2 mm) height should be provided by the machine cabinet.

 The depth inside the machine cabinet should not be less than 400 mm.

The dimensions of the instrument after being installed are shown below (the unit is mm).

4 Installation Procedures

Only authorized operators can execute the installation operation. Improper installation might

result in damage of the instrument or incorrect installation of the instrument on the rack.

(1). Install the side plates: fix the side plates (left and right) onto the bottom plate of the

rack using four M4 screws.

(2). Install the front plate: fix the front plate onto the side plates (left and right) of the rack

using six M4 screws.

(3). Place the instrument: place the instrument by aligning it with the edges of the side

plates (left and right) and front plate of the rack and fix the instrument onto the bottom

plate through presser feet using four M4 screws.

1 2

2 Installation Tool PH2 Phillips Screwdriver (recommended). 3 Installation Space The following requirements must be fulfilled by the machine ca

(4). Load into the machine cabinet: mount the rack with the instrument fixed to it into a standard 19-inch machine cabinet with four M6 screws and

Plus de documents pour Instruments de mesure Rigol MSO/DS2000A Series

Pas de commentaire