Rigol DS1000MD Spécifications télécharger pdf (Page 35)

Chapter 3 Performance Test RIGOL

Service Guide for DS1000E, DS1000D Series

3-7

4. Click Communication Setting and setup the communication interface under

using and the baud rate.

Figure 3-8 RS-232 interface setting

5. Press Utility→I/O Setting and set the baud rate as the same value in Ultrascope.

6. Click Tools → Connect to Oscilloscope; If successful, the corresponding

reminder light at the upper right corner of the software will be changed from red

to blue; otherwise, a prompting message will be appeared as below.

Figure 3-9 Fail prompt of RS-232 interface connection

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 62 63

Pas de commentaire

Rigol DS1000MD Spécifications Page 35