Rigol DS1000E series Guide de l'utilisateur télécharger pdf (Page 55)

RIGOL

User’s Guide for DS1000E, DS1000D Series

2-27

To Set up the Horizontal System

The oscilloscope shows the time per division in the scale readout. Since all active

waveforms use the same time base, the oscilloscope only displays one value for all

the active channels, except when using Delayed Scan, or Alternate Trigger.

The horizontal controls can change the horizontal scale and position of waveforms.

The horizontal center of the screen is the time reference for waveforms. Changing

the horizontal scale causes the waveform to expand or contract about the screen

center.

Horizontal position changes the displayed waveform position, relative to the trigger

point. Press the horizontal MENU button to display the horizontal menu as follows.

Figure 2- 37 Table 2- 19 The Horizontal menu

The parameter status symbol will be displayed on the screen during horizontal

system settings, which can help users to judge the channel status quickly.

Settings

Comments

Delayed

OFF

Turn on Delayed Scan mode

Turn off the Delayed Scan mode

Time Base

Y-T

X-Y

Roll

Show the relative relation between

vertical voltage and horizontal

time.

Show CH1 value at X axis; CH2

value at Y axis.

In Roll Mode, the waveform display

updates from right to left.

Sa Rate

Show system sample rate

Trig-offset

Reset

Adjust to the center

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 161 162

Pas de commentaire

Rigol DS1000E series Guide de l'utilisateur Page 55