Rigol DS1074B Guide de l'utilisateur télécharger pdf (Page 125)

RIGOL

User’s Guide for DS1000E, DS1000D Series

2-95

3. Using Automatic Measurement

1. Select the signal channel for measuring. CH1 or CH2 according to the signal of

interest.

Press soft buttons as follows: Measure→Source→CH1 or CH2.

2. To see all measurement values, set the Display All to ON. 18 measurement

parameters will be displayed on the screen.

3. Select parameters page for measuring; select voltage or time parameters pages

by pressing soft button as follows: Measure → Voltage or time → Vmax,

Vmin……

4. To get the measured value on the screen; select the parameters of interest by

pressing the soft button on the right of the menu, and read the data on the

bottom of the screen.

If the data is displayed as “*****”, it means the parameter cannot be measured

in current condition.

5. Clear the measure values: press Clear and all of the auto measure values would

disappear from the screen.

Figure 2- 117 Measurement display

Turn on/off the mass measurement

Clear measured data from screen

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 171 172

Pas de commentaire

Rigol DS1074B Guide de l'utilisateur Page 125