Rigol DS1074B Guide de l'utilisateur télécharger pdf (Page 19)

RIGOL

User’s Guide for DS1000E, DS1000D Series

1-7

oscilloscope:

 Align the slot in the probe connector with the key on the CH 1 BNC.

 Push to connect, and twist to the right to lock the probe in place.

Attach the probe tip and ground lead to the PROBE COMP connector.

Figure 1- 6

Attach the probe

② Set the probe attenuation to 10X. To do this, push CH1→Probe→10X.

Figure 1- 7 Figure 1- 8

Set attenuation on the probe Set attenuation in the menu

③ Push the AUTO button. Within a few seconds, a square wave will display.

④ Push the OFF button or push the CH1 button again to turn off Channel 1.

Push the CH2 button to turn on channel 2, repeat steps 2 and 3.

NOTE: The signal output from Probe compensator should only be used for probe

compensation, not for calibration.

Probe compensator

Probe scale

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 171 172

Pas de commentaire

Rigol DS1074B Guide de l'utilisateur Page 19