Rigol DM3058 Manuel d'utilisateur télécharger pdf (Page 44)

RIGOL

User’s Guide for DM3058/DM3058E

2-22

To Test Continuity

When the measured resistance in circuit is lower than selected one, it is considered

being connected by instrument. Next, we will introduce you how to test continuity

for circuit by using DM3058/DM3058E step by step to make you familiar with this

technique.

Operating Steps:

1. Press

to enter into the following interface.

Figure 2-26 Continuity Testing Interface

2. Connect test leads as the figure below. Red lead connects with HI terminal;

Black lead connects with LO terminal.

Figure 2-27 Sketch map for testing

3. Set the Short-circuit resistance.

Press Set to set up the resistance of short-circuit. The default value is set as

10Ω when leaving factory. Users may carry on the Continuity measurement

directly without modification.

Open or Closed Circuit

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 137 138

Pas de commentaire

Rigol DM3058 Manuel d'utilisateur Page 44