Rigol DS1000D Manuel d'utilisateur télécharger pdf (Page 21)

RIGOL

User’s Guide for DS1000E, DS1000D Series

1-11

Digital Leads (Only for DS1000D Series)

Digital leads are provided only for DS1000D series which have Logic Analyzer.

1. Switch off power supply of the device under test if necessary to avoid short

circuit. Since no voltage is applied to the leads at this step, you may keep the

oscilloscope on.

2. Connect one end of the flat cable FC1868 to the Logic Analyzer Input; connect

the other end to Logic Head LH1116. An identifier is located on each end of the

flat cable; it can only be connected in one way. It is unnecessary to switch off

power supply of your oscilloscope when connecting the cable.

Figure 1- 14

Connect the digital leads

CAUTION: Use only FC1868, LH1116, TC1100 and LC1150 made by

RIGOL for specified DS1000D series.

3. Connect a test clip to one lead wire; make sure it’s connection good.

Figure 1- 15

Input Interface of Digital Channel

Test clip

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 165 166

Pas de commentaire

Rigol DS1000D Manuel d'utilisateur Page 21