Rigol DS1000D Manuel d'utilisateur télécharger pdf (Page 5)

RIGOL

User’s Guide for DS1000E, DS1000D Series

III

Do not operate in wet/damp conditions

Do not operate in an explosive atmosphere

Keep product surfaces clean and dry

The disturbance test of all the models meet the limit values of A in the

standard of EN 61326: 1997+A1+A2+A3, but can’t meet the limit values

of B.

Measurement Category

The DS1000E, DS1000D series Digital Oscilloscope is intended to be used for

measurements in Measurement Category I.

Measurement Category Definitions

Measurement Category I is for measurements performed on circuits not directly

connected to MAINS. Examples are measurements on circuits not derived from

MAINS, and specially protected (internal) MAINS derived circuits. In the latter case,

transient stresses are variable; for that reason, the transient withstand capability of

the equipment is made known to the user.

WARNING

IEC Measurement Category I, The input terminals may be connected to circuit

terminal in IEC Category I installations for voltages up to 300 VAC. To avoid the

danger of electric shock, do not connect the inputs to circuit’s voltages above 300

VAC. Transient overvoltage is also present on circuits that are isolated from mains.

The DS1000E, DS1000D series Digital Oscilloscopes is designed to safely withstand

occasional transient overvoltage up to 1000Vpk. Do not use this equipment to

measure circuits where transient overvoltage could exceed this level.

1 2 3 4 5 6 7 8 9 10 ... 165 166

Pas de commentaire

Rigol DS1000D Manuel d'utilisateur Page 5