Rigol DS1000CA series Guide de l'utilisateur télécharger pdf (Page 20)

RIGOL

User‟s Guide for DS1000CA Series

1-8

Figure 1-5 Probe connection Figure 1-6 Probe adjustment

 Press CH1 → Probe → 10X to set probe attenuation of the oscilloscope, so as

to make sure the measurement result is correct. (Default probe attenuation

scale is 1X.)

 Attach the probe tip to the Probe compensator connector and the reference

lead to the ground pin. Press AUTO, within a few seconds, a square wave will

display (approximately 1 kHz 3 V peak- to- peak).

 Push the OFF button or push the CH1 button again to turn off Channel 1.

Push the CH2 button to turn on channel 2, repeat steps above.

Probe

compensator

connector

Ground pin

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 145 146

Pas de commentaire

Rigol DS1000CA series Guide de l'utilisateur Page 20