Rigol DS1000D Manuel d'utilisateur télécharger pdf (Page 135)

RIGOL

User’s Guide for DS1000E, DS1000D Series

3-1

Chapter 3 Application & Examples

Example 1: Taking Simple Measurements

The function is used to observe an unknown signal; to display, measure frequency,

and peak-to-peak amplitude.

To quickly display a signal, please do the steps as follow:

1. Set the probe and the channel attenuations to 10X

2. Connect signal to CH1 with the probe

3. Press the AUTO button

The oscilloscope sets the vertical, horizontal, and trigger controls at the best status

automatically. To optimize the waveform display, adjust these controls manually to

meet the requirements.

Selecting Automatic Measurements

The oscilloscope takes automatic measurements on most signals. To measure the

frequency and the peak-to-peak amplitude, do these steps as follows:

1. Measure peak-to-peak amplitude

Press Measure→Source→CH1 to set measurement source

Press Voltage →Vpp to select peak-to-peak measurements and the result will be

displayed on the screen.

2．Measure frequency

Press Measure→Source→CH1 to set measurement source

Press Time→Freq to select frequency measurements and the result will be

displayed on the screen.

NOTE: The frequency and peak-to-peak measurements are shown on the screen

and are updated periodically.

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 165 166

Pas de commentaire

Rigol DS1000D Manuel d'utilisateur Page 135