Rigol DS1000D Manuel d'utilisateur télécharger pdf (Page 19)

RIGOL

User’s Guide for DS1000E, DS1000D Series

1-9

 Align the slot in the probe connector with the button on the CH1 BNC.

 Push to connect, and twist to the right to lock the probe.

 Attach the probe tip and ground lead to the PROBE COMP connector.

Figure 1- 10

Attach the probe

② Set the probe attenuation to 10X. To do this, push CH1→Probe→10X.

Figure 1- 11 Figure 1- 12

Set attenuation on the probe Set attenuation in the menu

③ Push the AUTO button. Within a few seconds, a square wave will display.

④ Push the CH1 button again to turn off Channel1.

Push the CH2 button to turn on channel2, repeat steps 2 and 3.

NOTE: The signal output from Probe compensator should only be used for probe

compensation, not for calibration.

Probe compensator

Probe scale

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 165 166

Pas de commentaire

Rigol DS1000D Manuel d'utilisateur Page 19