Rigol MSO/DS1000Z Series Manuel d'utilisateur télécharger pdf (Page 201)

Chapter 13 Signal Source RIGOL

MSO1000Z/DS1000Z User’s Guide 13-5

To Output Pulse

Press Src1Conf to open the waveform setting menu. Press Wave and select "Pulse".

At this point, you can set the pulse parameters. For the detailed setting method, refer

to the introduction in "

To Output Sine". This section only introduces "DutyCycle".

Duty cycle is defined as the percentage that the high level takes up in the whole

pulse period.

Duty Cycle=t/T*100%

Figure 13-2 Duty Cycle Definition

Press DutyCycle to set the duty cycle of the pulse. For the setting method, please

refer to the introduction in "

Parameter Setting Method". The range is from 10%

to 90%.

To Output DC

Press Src1Conf to open the waveform setting menu. Press Wave and select "DC".

At this point, you can output a DC signal with the specified offset and impedance.

1. Source 1 output

Press Output to turn on or off the signal output.

2. Set the offset

Press Offset to set the offset of the DC signal. For the setting method, please

refer to the introduction in "

Parameter Setting Method". When the

impedance is HighZ, the range is from -2.5 V to +2.5 V; when the impedance is

set to 50 Ω, the range is from -1.25 V to +1.25 V.

3. Set the impedance

Press Impedance to set the output impedance of the signal generator. It can be

set to "HighZ" or "50Ω"

1 2 ... 196 197 198 199 200 201 202 203 204 205 206 ... 269 270

Pas de commentaire

Rigol MSO/DS1000Z Series Manuel d'utilisateur Page 201