Rigol DS1000M Guide de l'utilisateur télécharger pdf (Page 59)

RIGOL

User’s Guide for DS1000 Series

V. Using Vertical and

You can use the vertical controls to display waveforms, adjust vertical

and

, and set input parameters.

1. Using vertical

knob.

The vertical

can change the position of waveforms in all channels

(including MATH, REF and LA). The resolution of the knob changes according to

the change of the vertical level (The digital channels of Mixed Signal Oscilloscope

changes according to the changes of the waveforms displayed). Pressing this

knob will clear the channel offset to zero. (Exclude digital channels in the Mixed

Signal Oscilloscope)

2. Using vertical

knob.

The vertical

can change the vertical sensitivity of waveforms in all

channels (including MATH and REF, excluding LA). If the Volts/Div is set to

“Coarse”, the waveform scales in a 1-2-5 step sequence from 2 mV to 5 V. If the

Volts/Div is set to “Fine”, it scales to small steps between the coarse settings.

3. Channels can be adjusted by the vertical

and only when

they are selected.

4. When you change the vertical position, the position message is displayed on the

left bottom of the screen, in the same color as the corresponding channel. The

unit is V (Volts).

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 167 168

Pas de commentaire

Rigol DS1000M Guide de l'utilisateur Page 59