Rigol DS2000A Series Spécifications Page 17

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 390
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 16
2 Command System RIGOL
MSO2000A/DS2000A Programming Guide 2-1
2 Command System
This chapter introduces the command subsystems of MSO2000A/DS2000A command set.
The topics of this chapter:
:AUToscale
:CLEar
:RUN
:STOP
:SINGle
:TFORce
:TLHAlf
IEEE 488.2 Common Commands
:ACQuire Commands
:BUS<n> Commands
:CALCulate Commands
:CALibrate Commands
:CHANnel<n> Commands
:CURSor Commands
:DISPlay Commands
:FUNCtion Commands
:LA Commands (For MSO2000A/MSO2000A-S)
:LAN Commands
:MASK Commands
:MEASure Commands
:OUTPut<n> Commands (For MSO2000A-S/DS2000A-S)
:RECall Commands
:REFerence Commands
:SAVE Commands
:SOURce<n> Commands (For MSO2000A-S/DS2000A-S)
:SYSTem Commands
:TIMebase Commands
:TRACe<n> Commands (For MSO2000A-S/DS2000A-S)
:TRIGger Commands
:WAVeform Commands
Note:
1. Unless otherwise noted, the introductions and parameter ranges in this manual are based on
MSO2302A-S.
2. For parameter setting commands (such as time, frequency and amplitude), the oscilloscope can only
accept numbers and set the parameters using the default units; it cannot recognize the units sent
with the parameters. For the default unit of each parameter, please refer to the description in each
command in the following introductions.
Vue de la page 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 389 390

Commentaires sur ces manuels

Pas de commentaire