Rigol DS2000 Series Guide de l'utilisateur télécharger pdf (Page 152)

RIGOL 6 To Make Measurements

DS2000 User’s Guide

6-32

Track Mode

In this mode, one or two pairs of cursors will appear. You can adjust the two pairs of

cursors (cursor A and cursor B) to measure the X and Y values on two different

sources respectively. The points being measured on cursor A and B are marked by an

orange rectangle and rhombus respectively. When the cursors are moved horizontally,

the marks will position on the waveform automatically. When the waveform is

expanded or compressed horizontally, the marks will track the points being marked

at the last adjustment of the cursors.

Press Cursor  Mode  “Track” to turn on the cursor track function and the

measurement results will be displayed at the upper left corner of the screen in the

following mode.

 The X value at cursor A (A->X): take the trigger position as reference and “s” or

“Hz” (when measuring FFT waveform) as its unit.

 The Y value at cursor A (A->Y): take the channel GND as reference and use the

same unit as the current source.

 The X value at cursor B (B->X): take the trigger position as reference and “s” or

“Hz” (when measuring FFT waveform) as its unit.

 The Y value at cursor B (B->Y): take the channel GND as reference and use the

same unit as the current source.

 The horizontal difference between cursor A and B (△X).

 The reciprocal of the horizontal difference between cursor A and B (1/△X).

 The vertical difference between cursor A and B (△Y).

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 263 264

Pas de commentaire

Rigol DS2000 Series Guide de l'utilisateur Page 152