Rigol DS2000 Series Guide de l'utilisateur télécharger pdf (Page 155)

6 To Make Measurements RIGOL

DS2000 User’s Guide

6-35

Auto Mode

In this mode, one or more cursors will appear. You can use auto cursor measurement

to measure any of the 24 waveform parameters. Before using this mode, you need to

at least enable one auto measurement parameter and the number of cursors will

change with the measurement parameter enabled.

Press Cursor  Mode  “Auto” and the number of cursors displayed on the screen

is determined by the measurement parameter enabled (different measurement

parameter needs different number of cursors). Note that no cursor will be displayed

if no auto cursor measurement parameter is enabled or the measurement source has

no input. When the waveform is expanded or compressed horizontally, the cursor will

move accordingly.

If multiple measurement parameters are turned on later, you can use Meas.Para. to

switch among at most five measurement parameters that are turned on last and the

measurement parameter currently selected is high-lighted at the bottom of the

screen.

The following figure shows the auto measurement of the delay between two

channels.

1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 263 264

Pas de commentaire

Rigol DS2000 Series Guide de l'utilisateur Page 155